Dell EMC PowerEdge C6420, Manual

Page: 45 / 127

Option Description
Option Description
Capacity Specifies the total capacity of the hard drive. This field is undefined for removable media
devices such as optical drives.
NVMe Settings
The NVMe settings enable you to set the NVMe drives to either RAID mode or Non-RAID mode.
NOTE: To configure these drives as RAID drives, you must set the NVMe drives and the Embedded SATA option in the SATA
Settings menu to RAID mode. If not, you must set this field to Non-RAID mode.
Viewing NVMe Settings
To view the NVMe Settings screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3 On the System Setup Main Menu screen, click System BIOS .
4 On the System BIOS screen, click NVMe Settings .
NVMe Settings details
The NVMe Settings screen details are explained as follows:
Option Description
NVMe Mode Enables you to set the NVMe mode. This option is set to Non RAID by default.
Boot Settings
You can use the Boot Settings screen to set the boot mode to either BIOS or UEFI . It also enables you to specify the boot order.
• UEFI : The Unified Extensible Firmware Interface (UEFI) is a new interface between operating systems and platform firmware. The
interface consists of data tables with platform related information, also boot and runtime service calls that are available to the operating
system and its loader. The following benefits are available when the Boot Mode is set to UEFI :
• Support for hard drive partitions larger than 2 TB.
• Enhanced security (e.g., UEFI Secure Boot).
• Faster boot time.
• BIOS : The BIOS Boot Mode is the legacy boot mode. It is maintained for backward compatibility.
Pre-operating system management applications 45