4. Ensure that the processor and heat sink are properly installed.
5. Install the system cover.
6. Run the appropriate diagnostic test. See the Using system diagnostics section.
7. If the problem persists, see the Getting help section.
System messages
For information about the event and error messages generated by the system firmware and agents that monitor system components, go
to
Look Up
>
Error Code
, type the error code, and then click
Look it up
.
Warning messages
A warning message alerts you to a possible problem and prompts you to respond before the system continues a task. For example, before
you format a hard drive, a message warns you that you may lose all data on the hard drive. Warning messages usually interrupt the task
and need you to respond by typing y (yes) or n (no).
NOTE:
Warning messages are generated by either the application or the operating system. For more information, see
the documentation that shipped with the operating system or application.
Diagnostic messages
The system diagnostic utility generates messages if there are errors detected when you run diagnostic tests on your system. For more
information about system diagnostics, see the For information about the event and error messages generated by the system firmware and
agents that monitor system components, go to
Look Up
>
Error Code
, type the error code, and then click
Look it up
..
Alert messages
The systems management software generates alert messages for your system. Alert messages include information, status, warning, and
failure messages for drive, temperature, fan, and power conditions. For more information, see the systems management software
documentation links listed in the Documentation resources section of this manual.
118
Troubleshooting your system
