Next steps
1.
Install the cooling shroud.
2.
Install the power supply module(s) or power supply blank in their original locations.
3.
Follow the procedure listed in
After working inside your system
.
Related Links
Installing the cooling shroud
Installing a redundant AC power supply
Removing the power interposer board
System battery
Replacing the system battery
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1.
.
2.
Follow the procedure listed in
Before working inside your system
3.
Remove the cooling shroud.
WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the
battery only with the same or equivalent type recommended by the manufacturer. See your
safety information for additional information.
Steps
1.
Locate the battery socket. For more information, see
.
CAUTION: To avoid damage to the battery connector, you must firmly support the connector
while installing or removing a battery.
2.
To eject the battery, press firmly on the edge of the positive side of the battery in the direction of the
arrow as shown in the illustration below.
128
