Back to Contents Page
Solving Problems
Dell™ E228WFP Flat Panel Monitor User's Guide
Troubleshooting Your Monitor
General Problems
Product Specific Problems
Troubleshooting Your Soundbar
Troubleshooting Your Monitor
Self-Test Feature Check (STFC)
Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly
connected but the monitor screen remains dark, run the monitor self-test by performing the following steps:
1.
Turn off both your computer and monitor.
2.
Unplug the video cable from the back of the computer. To ensure proper Self-Test operation, remove both Digital (white connector) and the Analog(blue
connector) cables from the back of the computer.
3.
Turn on the monitor.
This box also appears during normal system operation if the video cable becomes disconnected or damaged.
4.
Turn off your monitor and reconnect the video cable, then turn on both your computer and the monitor.
If your monitor screen remains blank after you use the previous procedure, check your video controller and computer system; your monitor is functioning
properly.
OSD Warning Messages
One of the following warning messages may appear on the screen indicating that the monitor is out of synchronization.
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions
.
NOTE:
The floating 'Dell Self-test Feature Check' dialog box should appear on-screen on a black background if the monitor cannot
sense a video signal and is working correctly. While in self-test mode, the power LED remains green. Also, depending upon the
selected input, one of the dialogs shown below will continuously scroll through the screen.
or
or
1: Auto Detect (Analog Input)
Cannot Display This Video Mode
Optimum Resolution 1680 x1050 60Hz
or
1: Auto Detect (Digital Input)
Cannot Display This Video Mode
Optimum Resolution 1680 x1050 60Hz
