Troubleshooting cooling problems
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Ensure that the following conditions exist:
• System cover, cooling shroud, EMI filler panel, or back-filler bracket is not removed.
• Ambient temperature is not too high.
• External airflow is not obstructed.
• A cooling fan is not removed or has not failed.
• The expansion card installation guidelines have been followed.
Additional cooling can be added by one of the following methods:
From the iDRAC Web GUI:
1.
Click
Hardware
→
Fans
→
Setup
.
2.
From the
Fan Speed Offset
drop-down list, select the cooling level needed or set the minimum fan
speed to a custom value.
From F2 System Setup
1.
Select
iDRAC Settings
→
Thermal
, and set a higher fan speed from the fan speed offset or minimum
fan speed.
From RACADM commands
1.
Run the command
racadm help system.thermalsettings
For more information, see the
Integrated Dell Remote Access Controller User's Guide
at
dell.com/
idracmanuals
.
Troubleshooting cooling fans
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: In the event of a problem with a particular fan, the fan number is referenced by the system’s
management software, allowing you to easily identify and replace the proper fan by noting the fan
numbers on the cooling fan assembly.
Steps
1.
Remove the system cover.
2.
Reseat the fan or the fan's power cable.
104
