NOTE:
If you assign a new system and/or setup password with the jumper on pins 2 and 4, the system disables the
new password(s) the next time it boots.
5. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
6. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
7. Remove the system cover.
8. Move the jumper on the system board jumper from pins 2 and 4 to pins 4 and 6.
9. Install the system cover.
10. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
11. Assign a new system and/or setup password.
Related tasks
Removing the system cover
Installing the system cover
System board connectors and jumpers
Figure 77. System board connectors and jumpers
Table 33. System board connectors and jumpers
Item
Connector
Description
1
PCIE _G2_X4 (PCH)
PCIE Slot 3 (x4)
2
PCIE_G3_X16 (CPU1)
PCIe Slot 2 and PCIe Slot 1 (PCIe Slot is closer to the
CPU2 socket)
3
J-AMEA
iDrac ports card connector
4
CPU2_PWR_C (P3)
CPU2 power connector
5
Int_PCIE_G3_X8 (CPU2)
Internal PCIe slot
124
Jumpers and connectors
