For Data Domain HA systems, SSH keys created on the active node take 30 seconds
to one minute to propagate to the standby node.
Accepting the End User License Agreement (EULA)
The first time you log in to a Data Domain system, the End User License Agreement
(EULA) is displayed.
At the end of the EULA, you are prompted to accept it:
Press any key then hit enter to acknowledge the receipt of EULA
information
Note
The EULA
must be accepted by a customer. A Data Domain representative should not
accept this agreement. If a customer is not present, press
Ctrl-C
to exit from the
EULA acceptance screen and continue the installation.
The customer can later enter the following to redisplay the EULA and accept it:
system show eula
Run the configuration wizard
The CLI configuration wizard starts automatically the first time the system boots. The
wizard prompts you through a series of questions that provide just enough information
for initial system configuration and basic network connectivity.
Note
You can initiate the CLI configuration wizard manually by entering the
config setup
command.
Configuring the network
Procedure
1. Enter
yes
to configure the system for network connectivity.
Network Configuration
Configure Network at this time (yes|no) [no]:
yes
2. Enter
yes
to configure DHCP (Dynamic Host Configuration Protocol) to obtain
network parameters (such as, the host name, domain name, and IP addresses)
dynamically from a DHCP server. Or enter
no
to configure the parameters
manually.
Use DHCP
Use DHCP for hostname, domainname, default gateway
and DNS servers? (At least one interface needs to
be configured using DHCP) (yes|no|?)
3. Enter a fully qualified domain name (FQDN) for the host name; for example,
str01.yourcompany.com
. Or accept the host name, if the system was able to
discover it.
Enter the hostname for this system
(fully-qualified domain name)[]:
Configure System For Use
88
Data Domain DD9500 and DD9800 Systems
6.1
Hardware Overview and Installation Guide
