Steps
1. To remove the dummy metal bracket, insert a flat-head screwdriver in the hole of the bracket, push the bracket to release
the bracket, and then lift the bracket out from the system.
2. Insert the optional DisplayPort module into its slot from the inside of your computer.
3. Connect the DisplayPort module cable to the connector on the system board .
4. Replace the two (M3X3) screws to secure the optional DisplayPort module to the system.
Next steps
1. Install the
.
2. Install the
.
after working inside your computer
.
Removing optional VGA module
Prerequisites
before working inside your computer
.
2. Remove the
.
3. Remove the
.
About this task
The following images indicate the location of the optional VGA module and provide a visual representation of the removal
procedure.
Steps
1. Remove the two (M3X3) screws that secure the optional VGA module to the computer chassis.
80
Removing and installing components
Summary of Contents for D31M
