CAUTION:
To prevent damage to the memory module, hold the memory module by the edges. Do not touch the
components on the memory module.
Installing the memory modules
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the memory modules and provides a visual representation of the installation procedure.
Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Insert the memory module into the memory-module connector until the memory module snaps into position and the securing clip locks
in place.
NOTE:
The securing clips return to the locked position. If you do not hear the click, remove the memory module and
reinstall it.
NOTE:
If the memory module is difficult to remove, gently ease the memory module back and forth to remove it from
the slot.
NOTE:
To prevent damage to the memory module, hold the memory module by the edges. Do not touch the
components on the memory module.
Next steps
1. Install the
.
2. Follow the procedure in
After working inside your computer
.
30
Disassembly and reassembly
Summary of Contents for D28M
