Next steps
1. Install the
.
2. Follow the procedure in
After working inside your computer
.
Memory modules
Removing the memory modules
Prerequisites
1. Follow the procedure in
Before working inside your computer
.
2. Remove the
About this task
The following images indicate the location of the memory modules and provides a visual representation of the removal procedure.
Steps
1. Lay the chassis on the right side.
2. Use your fingertips to carefully spread apart the securing-clips on each end of the memory-module slot.
3. Grasp the memory module near the securing clip, and then gently ease the memory module out of the memory-module slot.
NOTE:
Repeat step 2 to step 4 to remove any other memory modules installed in your computer.
NOTE:
Note the slot and the orientation of the memory module in order to replace it in the correct slot.
NOTE:
If the memory module is difficult to remove, gently ease the memory module back and forth to remove it from
the slot.
Disassembly and reassembly
29
Summary of Contents for D28M
