Removing the system board
Prerequisites
Before working inside your computer
.
NOTE:
Your computer’s Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup
program after you replace the system board.
NOTE:
Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup
program. You must make the appropriate changes again after you replace the system board.
NOTE:
Before disconnecting the cables from the system board, note the location of the connectors so that you can
reconnect the cables correctly after you replace the system board.
2. Remove the
.
3. Remove the
.
4. Remove the
.
5. Remove the
.
6. Remove the
.
7. Remove the
8. Remove the
.
9. Remove the
.
10. Remove the
11. Remove the
12. Remove the
NOTE:
Remove the graphics-card rubber protector from the chassis before removing the system board.
13. Remove the
.
14. Remove the
.
15. Remove the
.
16. Remove the
.
NOTE:
Remove the power-supply cable clips from the power-supply cover before removing the system board.
17. Remove the
About this task
The following images indicate the location of the system board and provide a visual representation of the removal procedure.
Removing and installing components
93
Summary of Contents for D03T
