Dell C9000 series, Reference Manual

Page: 934 / 2286

Time since last interface status change: 02:37:06
Related
Commands show interfaces — displays the interface configuration.
interface loopback
Configure a Loopback interface.
C9000 Series
Syntax
interface loopback number
To remove a loopback interface, use the
no interface loopback number
command.
Parameters
number Enter a number as the interface number. The range is from 0 to
16383.
Defaults Not configured.
Command Modes CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Example
Dell(conf)# interface loopback 1655
Dell(conf-if-lo-1655)#
Interfaces 934