Dell C9000 series, Reference Manual

Page: 718 / 2286

Version Description
9.3(0.0) Introduced on the S4810 and S6000 platforms.
Usage Information A DCB map is a template used to configure DCB parameters and apply them on
converged Ethernet interfaces. DCB parameters include priority-based flow control
(PFC) and enhanced traffic selection (ETS).
To display the PFC and ETS settings in DCB maps, enter the
show qos dcb-map
command.
Use the
dcb-map
command to create a DCB map to specify PFC and ETS settings and
apply it on Ethernet ports. After you apply a DCB map to an interface, the PFC and ETS
settings in the map are applied when the Ethernet port is enabled. DCBx is enabled on
Ethernet ports by default.
The
dcb-map
command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the
no dcb-map map-name
command
in Interface configuration mode.
priority-pgid
Assign 802.1p priority traffic to a priority group in a DCB map.
C9000 Series
Syntax
priority-pgid dot1p0_group-num dot1p1_group-num dot1p2_group-num
dot1p3_group-num dot1p4_group-num dot1p5_group-num dot1p6_group-
num dot1p7_group-num
Parameters
dot1p0–7_group-
num Enter the priority group number for each 802.1p class of traffic
in a DCB map.
Defaults None
Command Modes DCB MAP
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.1) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
Data Center Bridging (DCB) 718