Dell C9000 series, Reference Manual

Page: 499 / 2286

redistribute ospf
Redistribute OSPF routes into BGP.
C9000 Series
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match
internal]] [route-map map-name ]
To stop redistribution of OSPF routes, use the
no redistribute ospf process-id
command.
Parameters
process-id Enter the number of the OSPF process. The range is from 1 to
65535.
match external {1 |
2} (OPTIONAL) Enter the keywords
match external
to
redistribute OSPF external routes. You can specify
1
or
2
to
redistribute those routes only.
match internal (OPTIONAL) Enter the keywords
match internal
to
redistribute OSPF internal routes only.
route-map map-
name
(OPTIONAL) Enter the keywords
route-map
then the name of a
configured route map.
Defaults Not configured.
Command Modes ROUTER BGP
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced the ability to substitute IGP cost for MED when a
peer/peer-group outbound route-map is set as
internal .
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Border Gateway Protocol 499