Dell C9000 series, Reference Manual

Page: 485 / 2286

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information When you apply a route map to outbound routes, only routes that match at least one
section of the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the
characteristics in the Route map used in this command. If you identify a peer by IP
address, the Route map overwrites either the inbound or outbound policies on that
peer.
neighbor route-reflector-client
Configure the router as a route reflector and the specified neighbors as members of the cluster.
C9000 Series
Syntax
neighbor { ip-address | peer-group-name } route-reflector-client
To remove one or more neighbors from a cluster, use the
no neighbor { ip-
address | peer-group-name } route-reflector-client
command. If you
delete all members of a cluster, you also delete the route-reflector configuration on
the router.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
All routers in the peer group receive routes from a route
reflector.
Defaults Not configured.
Command Modes ROUTER BGP
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Border Gateway Protocol 485