Configure your system to accept 4-byte formats before entering a 4 byte AS Number.
If the AS-PATH contains both public and private AS number or contains AS numbers of
an EBGP neighbor, the private AS numbers are not removed.
If a confederation contains private AS numbers in its AS-PATH, the software removes
the private AS numbers only if they follow the confederation numbers in the AS path.
Private AS numbers are from 64512 to 65535 (2 byte).
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
C9000 Series
Syntax
neighbor {
ip-address
|
peer-group-name
} route-map
map-name
{in |
out}
To remove the route map, use the
no neighbor {
ip-address
|
peer-group-
name
} route-map
map-name
{in | out}
command.
Parameters
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group.
map-name
Enter the name of an established route map.
If the Route map is not configured, the default is
deny
(to drop
all routes).
in
Enter the keyword
in
to filter inbound routes.
out
Enter the keyword
out
to filter outbound routes.
Defaults
Not configured.
Command Modes
ROUTER BGP
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.9(0.0)
Introduced on the C9010.
9.2(1.0)
Introduced on the Z9500.
Border Gateway Protocol
484
Summary of Contents for C9000 series
Page 1: ...Dell Networking Command Line Reference Guide for the C9000 Series Version 9 10 0 0 ...
Page 394: ...deny 14551 666 Dell Access Control Lists ACL 394 ...
Page 877: ...algorithm FIPS Cryptography 877 ...
Page 1297: ...Total 5 0 Total 5 active route s using 952 bytes IPv6 Basics 1297 ...
