neighbor filter-list
Configure a BGP filter based on the AS-PATH attribute.
C9000 Series
Syntax
neighbor {
ip-address
|
peer-group-name
} filter-list
as-path-name
{in | out}
To delete a BGP filter, use the
no neighbor {
ip-address
|
peer-group-name
}
filter-list
as-path-name
{in | out}
command.
Parameters
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to apply the filter to all routers
in the peer group.
as-path-name
Enter the name of an established AS-PATH access list (up to 140
characters).
If the AS-PATH access list is not configured, the default is
permit
(allow routes).
in
Enter the keyword
in
to filter inbound BGP routes.
out
Enter the keyword
out
to filter outbound BGP routes.
Defaults
Not configured.
Command Modes
• ROUTER BGP
• ROUTER BGP-address-family
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.9(0.0)
Introduced on the C9010.
9.2(1.0)
Introduced on the Z9500.
8.3.11.1
Introduced on the Z9000.
7.8.1.0
Introduced on the S-Series.
Increased the name string to accept up to 140 characters. Prior
to 7.8.1.0, ACL names were up to 16 characters long.
Border Gateway Protocol
472
Summary of Contents for C9000 series
Page 1: ...Dell Networking Command Line Reference Guide for the C9000 Series Version 9 10 0 0 ...
Page 394: ...deny 14551 666 Dell Access Control Lists ACL 394 ...
Page 877: ...algorithm FIPS Cryptography 877 ...
Page 1297: ...Total 5 0 Total 5 active route s using 952 bytes IPv6 Basics 1297 ...
