Dell C9000 series, Reference Manual

Page: 452 / 2286

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information To remove all configured debug commands for BGP, enter the
no debug ip bgp
command.
debug ip bgp keepalives
Display information about BGP keepalive messages.
C9000 Series
Syntax
debug ip bgp [vrf vrf-name ] [ A.B.C.D | X:X:X:X::X | peer-group
peer-group-name ] keepalives [in | out]
To disable debugging, use the
no debug ip bgp [vrf vrf-name ] [ A.B.C.D |
X:X:X:X::X | peer-group peer-group-name ] keepalives [in | out]
command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword
vrf
followed by the name of the
VRF to display BGP keepalive information corresponding to that
VRF.
A.B.C.D (OPTIONAL) Enter the IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group peer-
group-name
(OPTIONAL) Enter the keyword
peer-group
then the name of
the peer group.
in (OPTIONAL) Enter the keyword
in
to view only inbound
keepalive messages.
out (OPTIONAL) Enter the keyword
out
to view only outbound
keepalive messages.
Command Modes EXEC Privilege
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Border Gateway Protocol 452