Dell C9000 series, Reference Manual

Page: 364 / 2286

Parameters
community-list-
name Enter the name of a configured community list.
exact (OPTIONAL) Enter the keywords
exact
to process only those
routes with this community list name.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Related
Commands
ip community-list — configures an Community Access list.
set community — specifies a COMMUNITY attribute.
neighbor send-community — sends COMMUNITY attribute to peer or peer group.
match interface
To match routes whose next hop is on the interface specified, configure a filter.
C9000 Series
Syntax
match interface interface
To remove a match, use the
no match interface interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
Access Control Lists (ACL) 364