
dot1x server-timeout
Configure the amount of time after which exchanges with the server time-out.
C9000 Series
Syntax
dot1x server-timeout
seconds
To return to the default, use the
no dot1x server-timeout
command.
Parameters
seconds
Enter a time-out value in seconds. The range is from 1 to 300,
where 300 is implementation dependant. The default is
30
.
Defaults
30
seconds
Command Modes
INTERFACE
INTERFACE (BATCH MODE)
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.10(0.0)
Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0)
Introduced on the C9010.
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.11.1
Introduced on the Z9000.
7.6.1.0
Introduced on the C-Series and S-Series.
7.4.1.0
Introduced on the E-Series.
Usage Information When you configure the
dot1x server-timeout
value, take into account the
communication medium used to communicate with an authentication server and the
number of RADIUS servers configured. Ideally, the
dot1x server-timeout
value (in
seconds) is based on the configured RADIUS-server timeout and retransmit values and
802.1X
257
Summary of Contents for C9000 series
Page 1: ...Dell Networking Command Line Reference Guide for the C9000 Series Version 9 10 0 0 ...
Page 394: ...deny 14551 666 Dell Access Control Lists ACL 394 ...
Page 877: ...algorithm FIPS Cryptography 877 ...
Page 1297: ...Total 5 0 Total 5 active route s using 952 bytes IPv6 Basics 1297 ...