•
•
•
•
•
•
•
•
back-up destination
Configure the IPv4 or IPv6 address of the management interface on the remote VLT peer to be used as the
endpoint of the VLT backup link for sending out-of-band hello messages.
C9000 Series
Syntax
back-up destination {[
ipv4–address
] | [ipv6
ipv6–address
]
[interval
seconds
]}
Parameters
ipv4–address
Enter the IPv4 address of the backup destination.
ipv6
Enter the keyword
ipv6
then an IPv6 address in the X:X:X:X::X
format.
interval
seconds
Enter the keyword
interval
to specify the time interval to send
hello messages. The range is from 1 to 5 seconds. The default is
1 second.
Defaults
1 second
Command Modes
VLT DOMAIN
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.9(0.0)
Introduced on the C9010.
9.5(0.1)
Introduced on the Z9500.
9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.2(0.2)
Added support for IPv6.
Virtual Link Trunking (VLT)
2205
Summary of Contents for C9000 series
Page 1: ...Dell Networking Command Line Reference Guide for the C9000 Series Version 9 10 0 0 ...
Page 394: ...deny 14551 666 Dell Access Control Lists ACL 394 ...
Page 877: ...algorithm FIPS Cryptography 877 ...
Page 1297: ...Total 5 0 Total 5 active route s using 952 bytes IPv6 Basics 1297 ...
