Dell C9000 series, Reference Manual, Page: 2068 / 2286

snmp trap link-status
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
C9000 Series
Syntax
snmp trap link-status
To disable sending link trap messages, use the
no snmp trap link-status
command.
Defaults Enabled.
Command Modes INTERFACE
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information If the interface is expected to flap during normal usage, you could disable this
command.
Syslog Commands
The following commands allow you to configure logging functions on all Dell Networking switches.
Simple Network Management Protocol (SNMP) and Syslog 2068