Dell C9000 series, Reference Manual

Page: 2057 / 2286

snmp-server host
Configure the recipient of an SNMP trap operation.
C9000 Series
Syntax
snmp-server host ip-address | ipv6-address | hostname [vrf
management traps | informs] [version 1 | 2c | 3] [auth | no auth |
priv] [community-string] [udp-port port-number] [notification-
type]
To remove the SNMP host, use the no snmp-server host ip-address | ipv6-address |
hostname [vrf management traps | informs] [version 1 | 2c | 3] [auth | noauth | priv]
[community-string] [udp-port number] [notification-type] command.
Parameters
ip-address Enter the keyword
host
followed by the IP address of the host
(Configurable hosts are limited to 16).
ipv6-address Enter the keyword host then the IPv6 address of the host in the
x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
hostname Enter the keyword
host
followed by the name of a host already
configured and recognized by the switch.
vrf management Enter the keyword
vrf
followed by the keyword management
to specify that management vrf will be used to send traps and
informs.
traps (OPTIONAL) Enter the keyword
traps
to send trap notifications
to the specified host. The default is traps .
informs (OPTIONAL) Enter the keyword
informs
to send inform
notifications to the specified host. The default is traps .
version 1 | 2c | 3 (OPTIONAL) Enter the keyword version to specify the security
model then the security model version number
1
,
2c
, or
3
:
• Version
1
is the least secure version.
• Version
3
is the most secure of the security modes.
• Version
2c
allows transmission of informs and counter 64,
which allows for integers twice the width of what is
normally allowed.
The default is version 1 .
auth (OPTIONAL) Enter the keyword
auth
to specify authentication
of a packet without encryption.
Simple Network Management Protocol (SNMP) and Syslog 2057