Dell C9000 series, Reference Manual

Page: 2018 / 2286

Version Description
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series, E-Series, and E-Series ExaScale.
7.4.1.0 Introduced
protocol-tunnel
Enable protocol tunneling on a stacked (Q-in-Q) VLAN for specified protocol packets.
C9000 Series
Syntax
protocol-tunnel {rate-limit rate | stp}
To disable protocol tunneling for a Layer 2 protocol, use the
no protocol-tunnel
command.
Parameters
rate-limit rate Enter the keyword
rate-limit
followed by a number for the
rate-limit for tunneled packets on the VMAN. The range is from
64 to 320.
stp Enter the keyword
stp
to enable protocol tunneling on a
spanning tree, including STP, MSTP, RSTP, and PVST.
Defaults none
Command Modes CONF-IF-VLAN
Command History This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
Service Provider Bridging 2018