Dell C9000 series, Reference Manual

Page: 2000 / 2286

Defaults Not configured.
Command Modes CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S-Series and Z9000.
Usage Information The
source-interface interface
attribute is applicable for both the
SSH client
as well as the
COPY
(SCP) commands. Using these attributes the client session tags an
error to the user during run time, in case there is a mismatch between this command
and the
ip ssh vrf
command.
Example
Dell(conf)#ip ssh source-interface tengigabitethernet 0/36
Dell(conf)#do ssh 10.10.10.2 -l admin
Dell(conf)#no ip ssh source-interface
show crypto
Display the public part of the SSH host-keys.
C9000 Series
Syntax
NOTE: Some of the parameters in this command require licensing to access. For
more information, contact your Dell Networking representative.
show crypto key mypubkey {rsa | rsa1}
Parameters
Key Enter the keyword
key
to display the host public key.
mypubkey Enter the keyword
mypubkey
to display the host public key.
rsa Enter the keyword
rsa
to display the host SSHv2 RSA public key.
rsa1 Enter the keyword
rsa1
to display the host SSHv1 RSA public
key.
NOTE: If you enable FIPS mode, this parameter is not
available.
Defaults none
Security 2000