Command History
Version
Description
9.10(0.0)
Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0)
Introduced on the C9010.
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
Usage Information When the total memory utilization for a CPU exceeds the configured high/low
threshold for a given time, a threshold notification is sent as an SNMP trap. If a low
threshold value is not specified, the low threshold value is set to the same value as the
high threshold value.
To return the memory thresholds to the default values, enter the
no util-threshold
mem all | cp | lp
slot—id
| pe | rp
command.
Use this command in Configuration Terminal Batch mode to configure the memory
utilization thresholds in a dual-homing setup.
Example cp
Dell(conf)# util-threshold memory cp high 75 low 67
Example pe
Dell(conf)# util-threshold memory pe high 85 low 70
Related
Commands
•
– Display the configured values of memory
utilization thresholds.
•
– Display the configured values of CPU utilization
thresholds.
virtual-ip
Configure a virtual IP address for the active management interface. You can configure virtual addresses both
for IPv4 and IPv6 independently.
C9000 Series
Syntax
virtual-ip {
ipv4-address
|
ipv6-address
}
To return to the default, use the
no virtual-ip {
ipv4-address
|
ipv6-
address
}
command.
Control and Monitoring
197
Summary of Contents for C9000 series
Page 1: ...Dell Networking Command Line Reference Guide for the C9000 Series Version 9 10 0 0 ...
Page 394: ...deny 14551 666 Dell Access Control Lists ACL 394 ...
Page 877: ...algorithm FIPS Cryptography 877 ...
Page 1297: ...Total 5 0 Total 5 active route s using 952 bytes IPv6 Basics 1297 ...
