Dell C9000 series, Reference Manual, Page: 1898 / 2286

Usage Information When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor
routers are possible.
To ensure that only specific interfaces are receiving and sending data, use the
passive-interface
command with the
neighbor
command.
Related
Commands passive-interface — sets the interface to only listen to RIP broadcasts.
network
Enable RIP for a specified network. To enable RIP on all networks connected to the switch, use this
command.
C9000 Series
Syntax
network ip-address
To disable RIP for a network, use the
no network ip-address
command.
Parameters
ip-address Specify an IP network address in dotted decimal format. You
cannot specify a subnet.
Defaults No RIP network is configured.
Command Modes ROUTER RIP
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
Routing Information Protocol (RIP) 1898