Dell C9000 series, Reference Manual

Page: 1895 / 2286

Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information To enable the interface to send both version of RIP packets, use the
ip rip send
version 1 2
command.
Related
Commands
ip rip receive version — sets the RIP version for the interface to receive traffic.
version — sets the RIP version for the switch software.
ip split-horizon
Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme
prevents any routes learned over a specific interface to be sent back out that interface.
C9000 Series
Syntax
ip split-horizon
To disable split-horizon, use the
no ip split-horizon
command.
Defaults Enabled
Command Modes INTERFACE
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
Routing Information Protocol (RIP) 1895