Dell C9000 series, Reference Manual

Page: 1846 / 2286

Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage Information A color map outlines the codepoint mappings to the appropriate color mapping (green,
yellow, red) for the traffic. The system uses this information use to handle the traffic on
the interface based on the traffic priority and places it into the appropriate shaping
queue. You cannot delete a DSCP color map when it is configured on an interface. If
you do, all the DSCP values are set to green (low drop precedence). To delete the
DSCP color map that is being used by one or more interfaces, remove the DSCP map
from each interface.
Use this command in Configuration Terminal Batch mode to configure the DSCP color
map in a dual-homing setup.
Example
Dell(conf)#qos dscp-color-map mymap
Related
Commands
qos dscp-color-map — associates the DSCP color map profile with an interface so that
all IP packets received on it is given a color based on that color map
dscp — sets the number of specific DSCP values for color map profile to yellow or red.
qos dscp-color-policy
Associates the DSCP color map profile with an interface so that all IP packets received on it is given a color
based on that color map.
C9000 Series
Syntax
dscp-color-policy color-map-profile-name
To remove a color policy map profile, use the no
dscp-color-policy color-map-
profile-name
command.
Quality of Service (QoS) 1846