Dell C9000 series, Reference Manual

Page: 1468 / 2286

Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage Information Use this command to create an object that tracks the line-protocol state of a Layer 2
interface by monitoring its operational status (UP or DOWN).
When the link-level status goes down, the tracked object status is considered to be
DOWN; if the link-level status is up, the tracked object status is considered to be UP.
Related
Commands
• show track – displays information about tracked objects, including configuration,
current state, and clients which track the object.
• track interface ip routing – configures object tracking on the routing status of an
IPv4 Layer 3 interface.
track ip route metric threshold
Configure object tracking on the threshold of an IPv4 route metric.
C9000 Series
Syntax
track object-id ip route ip-address/prefix-len metric threshold
To return to the default setting, use the
no track object-id
command.
Parameters
object-id Enter the ID number of the tracked object. The range is 1 to 500.
ip-address/
prefix-len Enter an IPv4 address in dotted decimal format. The valid IPv4
prefix lengths are from /0 to /32.
Defaults none
Command Modes CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Object Tracking 1468