Dell C9000 series, Reference Manual

Page: 1274 / 2286

ipv6 flowlabel-zero
Configure system to set the flow label field in the packets to zero.
C9000 Series
Syntax
ipv6 flowlabel-zero
To remove 0 from the flow label field and allow the protocol operations to fill the field,
use the
no ipv6 flowlabel-zero
command.
Default Disabled
Command Modes CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information If the flowlabel value is already set for BGP or SSH, the system defaults to the already
configured value. All packets on the same connection are considered part of the same
flow by the system. For new connections, set the new flowlabel to zero.
IPv6 Basics 1274