Dell C9000 series, Reference Manual

Page: 1202 / 2286

You can specify the weight value only to destination address and not on the egress
port.
A route is considered for weighted ECMP calculations only if each path corresponding
to that route is configured with a weight.
You cannot use the VRF attribute of this command to configure routes in a
management VRF. When a specific VRF is deleted, all the configured static routes
corresponding to that VRF are automatically removed.
Example
Dell(conf)#ip route 1.1.1.0/24 4.4.4.2 weight 100
Dell(conf)#ip route 1.1.1.0/24 6.6.6.2 weight 200
Dell(conf)#do show running-config | grep route ip route
1.1.1.0/24 4.4.4.2 weight 100 ip route 1.1.1.0/24 6.6.6.2 weight
200
Dell(conf)#ip route vrf test 1.1.1.0/24 4.4.4.2 weight 100
Dell(conf)#ip route vrf test 1.1.1.0/24 6.6.6.2 weight 200
Dell(conf)#
Dell(conf)#do show running-config | grep route ip route vrf test
1.1.1.0/24 4.4.4.2 weight 100 ip route vrf test 1.1.1.0/24
6.6.6.2 weight 200
Related
Commands show ip route — views the switch routing table.
ip source-route
Enable the system to forward IP packets with source route information in the header.
C9000 Series
Syntax
ip source-route
To drop packets with source route information, use the
no ip route-source
command.
Defaults Enabled.
Command Modes CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
IPv4 Routing 1202