![Dell C9000 series Reference Manual Download Page 1193](http://html.mh-extra.com/html/dell/c9000-series/c9000-series_reference-manual_230451193.webp)
Version
Description
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series ExaScale.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.3.1.0
Introduced for the E-Series.
Usage Information This command disables the hop field increments when boot requests are relayed to a
DHCP server through the system. If the incoming boot request already has a non-zero
hops field, the message is relayed with the same value for hops. However, the message
is discarded if the hops field exceeds 16, to comply with the relay agent behavior
specified in RFC 1542.
Related
Commands
•
— specifies the destination broadcast or host address for DHCP
server requests.
•
— displays the current configuration and changes from the
default values.
ip host
Assign a name and IP address for the host-to-IP address mapping table.
C9000 Series
Syntax
ip host name
ip-address
To remove an IP host, use the
no ip host name [
ip-address
]
command.
Parameters
name
Enter a text string to associate with one IP address.
ip address
Enter an IP address, in dotted decimal format, to be mapped to
the name.
Defaults
Not configured.
Command Modes
CONFIGURATION
IPv4 Routing
1193
Summary of Contents for C9000 series
Page 1: ...Dell Networking Command Line Reference Guide for the C9000 Series Version 9 10 0 0 ...
Page 394: ...deny 14551 666 Dell Access Control Lists ACL 394 ...
Page 877: ...algorithm FIPS Cryptography 877 ...
Page 1297: ...Total 5 0 Total 5 active route s using 952 bytes IPv6 Basics 1297 ...