Dell C9000 series, Reference Manual

Page: 1192 / 2286

Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information You can only configure one domain name with the
ip domain-name
command. To
configure more than one domain name, configure the
ip domain-list
command up
to six times.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the
ip name-server
command
• enable DNS with the
ip domain-lookup
command
To view current bindings, use the
show hosts
command.
Related
Commands
ip domain-list — configures additional names.
ip helper-address hop-count disable
Disable the hop-count increment for the DHCP relay agent.
C9000 Series
Syntax
ip helper-address hop-count disable
To re-enable the hop-count increment, use the
no ip helper-address hop-
count disable
command.
Defaults Enabled; the hops field in the DHCP message header is incremental by default.
Command Modes CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
IPv4 Routing 1192