Dell C9000 series, Reference Manual

Page: 1190 / 2286

If you configure both the
ip domain-name
and
ip domain-list
commands, the
software tries to resolve the name using the
ip domain-name
command. If the name
is not resolved, the software goes through the list of names configured with the
ip
domain-list
command to find a match.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the
ip name-server
command
• enable DNS with the
ip domain-lookup
command
To view current bindings, use the
show hosts
command. To view a DNS-related
configuration, use the
show running-config resolve
command.
Related
Commands ip domain-name — specifies a DNS server.
ip domain-lookup
Enable dynamic host-name to address resolution (that is, DNS).
C9000 Series
Syntax
ip domain-lookup
To disable DNS lookup, use the
no ip domain-lookup
command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
IPv4 Routing 1190