• null — Causes an encryption policy configured for the area
to not be inherited on the interface.
Defaults
none
Command Modes
CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.9(0.0)
Introduced on the C9010.
9.2(1.0)
Introduced on the Z9500.
9.2(0.0)
Introduced on the Z9000, S4810, and S4820T.
Usage Information
• Both sides of the link must specify the same transform set.
• You can create up to 64 transform sets.
Example
Dell(conf)#int ten 0/4
Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 0/6
Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64
crypto ipsec policy
Create a crypto policy used by ipsec.
C9000 Series
Syntax
crypto ipsec policy
name seq-num
ipsec-manual
To delete a crypto policy entry, use the
no crypto ipsec policy
name seq-num
ipsec-manual
command.
Parameters
name
Enter the name for the crypto policy set.
seq-num
Enter the sequence number assigned to the crypto policy entry.
Defaults
none
Command Modes
CONFIGURATION
Internet Protocol Security (IPSec)
1157
Summary of Contents for C9000 series
Page 1: ...Dell Networking Command Line Reference Guide for the C9000 Series Version 9 10 0 0 ...
Page 394: ...deny 14551 666 Dell Access Control Lists ACL 394 ...
Page 877: ...algorithm FIPS Cryptography 877 ...
Page 1297: ...Total 5 0 Total 5 active route s using 952 bytes IPv6 Basics 1297 ...