Dell C9000 series, Reference Manual

Page: 1144 / 2286

Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.1) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on S-Series and Z–Series.
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield
results.
debug ip igmp snooping
Enable debugging of IGMP snooping packets on interfaces and groups.
C9000 Series
Syntax
debug ip igmp snooping [ group address | interface ]
• To disable debugging of IGMP snooping, use the
no debug ip igmp snooping
[ group address | interface ]
command.
• To disable all debugging, use the
undebug all
command.
Parameters
snooping Enter the keyword snooping to enable debugging of IGMP
snooping.
group-address (OPTIONAL) Enter the IP multicast group address in dotted
decimal format.
interface interface Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For a port channel interface, enter the keywords
port-
channel
then a number.
Defaults Disabled.
Command Modes EXEC Privilege
Internet Group Management Protocol (IGMP) 1144