Dell C9000 series, Reference Manual

Page: 1136 / 2286

Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Expanded to support the
exclude
and
include
options.
Usage Information A group in
include
mode must have at least one source address defined. In
exclude
mode, if you do not specify a source address, The system implicitly assumes all sources
are included. If you do not specify either
include
or
exclude
, the system implicitly
assumes a IGMPv2 static join.
Command Limitations
• Only one mode (
include
or
exclude
) is permitted per multicast group per
interface. To configure another mode, all sources belonging to the original mode
must be unconfigured.
• If a static configuration is present and a packet for the same group arrives on an
interface, the dynamic entry completely overwrites all the static configuration for
the group.
Related
Commands show ip igmp groups — displays IGMP group information.
ip igmp version
Manually set the version of the router to IGMPv2 or IGMPv3.
C9000 Series
Syntax
ip igmp version {2 | 3}
Parameters
2 Enter the number 2 to set the IGMP version number to IGMPv2.
3 Enter the number 3 to set the IGMP version number to IGMPv3.
Internet Group Management Protocol (IGMP) 1136