Dell C9000 series, Reference Manual

Page: 1018 / 2286

channel-member
Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.
C9000 Series
Syntax
channel-member interface
To delete an interface from a Port Channel, use the
no channel-member interface
command.
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/port,
peid/stack-unit/port-id , or number information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For a port extender Gigabit Ethernet interface, enter the
keyword
peGigE
then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id
range is from 1 to 48.
Defaults Not configured.
Command Modes INTERFACE PORTCHANNEL
Command History This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
Interfaces 1018