Dell C9000 series, Reference Manual

Page: 1013 / 2286

Egress Interface Selection (EIS)
Commands
The following commands are Egress Interface Selection (EIS) commands.
application
Configure the management egress interface selection.
C9000 Series
Syntax
application {all | application-type }
To remove a management application configuration, use the
no application {all
| application-type }
command.
Parameters
application-type Enter any of the following keywords:
• For DNS, enter the keyword
dns
.
• For FTP, enter the keyword
ftp
.
• For NTP, enter the keyword
ntp
.
• For Radius, enter the keyword
radius
.
• For sFlow collectors, enter the keyword
sflow-
collector
.
• For SNMP (traps and MIB responses), enter the keywords
snmp
.
• For SSH, enter the keyword
ssh
.
• For Syslog, enter the keyword
syslog
.
• For TACACS, enter the keyword
tacacs
.
• For Telnet, enter the keyword
telnet
.
• For TFTP, enter the keyword
tftp
.
all Configure all applications.
Defaults None.
Command Modes EIS Mode (conf-mgmt-eis)
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
Interfaces 1013