For instructions, see the documentation accompanying the card.
2
Press tab A and rotate the latch clockwise.
3
Press tab B and rotate the latch down.
4
Holding the card by its edges, position the card so that the card-edge connector aligns with the expansion card connector.
5
Insert the card-edge connector firmly into the expansion card connector until the card is fully seated.
6
Close the latches of tab A and tab B.
Figure 34. Installing an expansion card into the expansion card riser 1
1
tab A
2
expansion card riser 1 cage
3
expansion card connector
4
tab B
5
latch
6
expansion card
Next steps
1
Install the expansion card riser.
2
If applicable, connect any cables to the expansion card.
3
Follow the procedure listed in the After working inside your appliance section.
4
Install any device drivers required for the card as described in the documentation for the card.
Removing the riser 1 blank
Prerequisites
1
Follow the safety guidelines listed in the Safety instructions section.
2
Follow the procedure listed in the Before working inside your appliance section.
3
Remove the expansion card riser.
Steps
Press the tabs on the riser 1 blank and push the riser 1 blank out of the chassis.
Installing and removing components
77
