Figure 22 Pull the inner rails out of the rack
2. Locate the rear rail standoff on each side of the X400 capacity cube. Position
the X400 capacity cube above the rails and lower the rear rail standoffs into the
rear J-slots on the slide assemblies.
3. Rotate the X400 capacity cube downward until all the rail standoffs are seated
in the J-slots.
Figure 23 Install the X400 capacity cube in the rails
4. Push the X400 capacity cube inward until the lock levers click into place.
5. Pull the blue slide release lock tabs forward on both rails and slide the X400
capacity cube into the rack. The slam latches will engage to secure the X400
capacity cube in the rack.
Install X400 cubes in the rack
PowerProtect X400 Appliance Hardware Configuration and Installation Guide
33
