CAUTION:
Be careful regarding the control panel LEDs while installing the backplane to the chassis.
2. Holding the plastic handle, slide the backplane towards the front until the chassis guide pins are secure.
Figure 72. Installing the backplane/midplane assembly
3. Replace the 24 screws on the backplane and four screws on the sides of the chassis to secure the backplane/midplane
assembly to the chassis.
4. Connect all the cables to the connectors on the backplane board.
Next steps
1.
2.
3.
.
4.
5.
Install the power distribution board
.
6.
7.
8.
.
9.
10.
.
11. Follow the procedure listed in
After working inside the system
Intrusion switch module
Removing the front intrusion switch
Prerequisites
1. Follow the safety guidelines listed in
.
2. Follow the procedure listed in the
Before working inside your system
66
Installing and removing enclosure components
