Figure 76. Installing the air shroud
Next steps
1. Install the
2.
3. Follow the procedure listed in
After working inside your system
Intrusion switch module
Removing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Before working inside your system
.
3.
4.
5. Keep the plastic scribe ready.
Steps
1. Disconnect and remove the intrusion switch cable from the connector on the system board.
Observe the routing of the cable as you remove it from the system.
2. Using a plastic scribe, slide the intrusion switch out of the intrusion switch slot.
98
Installing and removing system components
