Figure 88. GPU riser 1 removal
Next steps
.
Installing the GPU riser 1
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Before working inside your system
.
3. If removed,
install the GPU in the GPU riser
.
Steps
1. Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the chassis.
2. Lower the whole assembly into place and press the touch points until it is fully seated.
3. Tighten the one blue thumb screw located at the front of the assembly, and two blue thumb screws located at the rear or the
assembly.
4. Re-connect the cables to the interposer and power interposer board.
116
Installing and removing system components
