System
Maximum weight (with all drives/SSDs)
10 x 2.5 inch drive system
16.8 kg (37 lb)
Processor specifications
The PowerEdge R440 system supports up to two Intel Xeon Processor Scalable Family processors.
PSU specifications
The PowerEdge R440 system supports the following AC power supply units (PSU).
Table 16. PSU specifications
PSU
Class
Heat dissipation
(maximum)
Frequency
Voltage
550 W AC
Platinum
2559 BTU/hr
50/60 Hz
100–240 V AC, autoranging
450 W AC
Bronze
1871 BTU/hr
50/60 Hz
100–240 V AC, autoranging
NOTE:
Heat dissipation is calculated using the PSU wattage rating.
NOTE:
This system is also designed to connect to the IT power systems with a phase-to-phase voltage not exceeding 230 V.
System battery specifications
The PowerEdge R440 system supports CR 2032 3.0-V lithium coin cell system battery.
Expansion bus specifications
The PowerEdge R440 system supports PCI express (PCIe) generation three expansion cards, which must be installed on the system board
using expansion card risers. The R440 system supports three types of expansion card risers.
Table 17. Expansion card riser configurations
Expansion card riser
PCIe slots on the riser
Processor connection Height
Length
Slot width
Riser 1A
Slot 1
Processor 1
Low Profile
Half Length
x16
Slot 2
Processor 1
Low Profile
Half Length
x16
Riser 2A
Slot 3
Processor 2
Low Profile
Half Length
x16
Riser 1B
Slot 1
Processor 1
Low Profile
Half Length
x16
Riser 2B
Slot 2
Processor 2
Full Height
Three-fourth Length
x16
Riser 1B
Slot 1
Processor 1
Low Profile
Half Length
x16
Memory specifications
The PowerEdge R440 system supports 16 DDR4 registered DIMM (RDIMMs) slots. Supported memory bus frequencies are 2666 MT/s,
2400 MT/s, 2133 MT/s, and 1866 MT/s.
Technical specifications
25
