4
Remove the BOSS card.
NOTE:
The procedure to remove the BOSS card is similar to the removing an expansion card.
Steps
1
Align the M.2 SSD module at an angle with the BOSS card connector.
2
Insert the M.2 SSD module until it is firmly seated in the BOSS card connector.
3
Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS card with the screw.
Figure 48. Installing the M.2 SSD module
Next steps
1
Install the BOSS card.
NOTE:
The procedure to install the BOSS card is similar to removing an expansion card.
2
3
Follow the procedure listed in the
After working inside your system
System battery
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. See the
safety instructions that came with your system for more information.
1
Follow the safety guidelines listed in the
..
2
Follow the procedure listed in the
Before working inside your system
3
.
76
Installing and removing system components
