Dell EMC Isilon, Configuration Manual, Page: 19 / 24

Enabling motion detection
If motion detection is not working, you must enable a new rule for motion detection.
Procedure
1. Disable the Default Record on Motion Rule on the management server.
2. Add a new rule named Record Always using the following definition:
Perform an action in a time interval
always
start recording
immediately
on
All Cameras
Perform an action when time interval ends
stop recording
immediately
Modifying the number of archive process threads
When using archive storage, such as NAS attached Isilon scale-out cluster, each
XProtect Corporate recording server must be modified to use either three or four
archive processes. By default, XProtect uses a single thread.
Procedure
1. Stop the Milestone XProtect Corporate Recording Server Service.
2. Go to:
C:\ProgramData\Milestone\XProtect Recording Server
.
3. Open the
RecorderConfig
file.
4. Edit the file as follows to change the low priority archive thread pool size to 3
and the high priority archive thread pool size to 4:
<thread_pools>
<delete_thread_pool_size>2</delete_thread_pool_size
<low_priority_archive_thread_pool_size>3</
low_priority_archive_thread_pool_size>
<high_priority_archive_thread_pool_size>4</
high_priority_archive_thread_pool_size>
</thread_pools>
5. Save the file.
6. Start the Milestone XProtect Corporate Recording Server Service.
Note
These steps apply to XProtect starting with version 2014.
XProtect-specific configuration
Enabling motion detection 19