NOTE:
Push the black card holder to hold the card in the riser.
Figure 89. Closing the card holder on the expansion card riser
Next steps
1. If applicable, connect the cables to the expansion card.
2. Follow the procedure listed in
After working inside your system
on page 26.
3. Install any device drivers required for the card as described in the documentation for the card.
Optional serial COM port
Removing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
on page 25.
2. Follow the procedure listed in the
Before working inside your system
Steps
1.
and disconnect the serial COM port cable from the connector on the rear I/O board.
2. Open the latch on the expansion card riser and slide the serial COM port out of the expansion card riser.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components
93
