Next steps
1
Connect all the cables.
2
Install the all drives.
3
Install the top cover.
4
Follow the procedure listed in
After working inside your system
Power supply unit
Removing a power supply unit
Prerequisites
CAUTION:
The power supply is only hot-swappable if you have a redundant system with all power supplies installed. If you only
have one power supply installed, before removing or replacing the power supply, you must first take the server out of service,
turn off all peripheral devices connected to the system, turn off the system by pressing the power button, and unplug the AC
power cord from the system or wall outlet.
1
Follow the safety guidelines listed in
2
Disconnect the power cable from the power source and from the PSU you intend to remove.
Step
Push the latch in the direction shown while pulling out of power supply module by the handle.
Figure 22. Removing a power supply unit
Next step
Install the Power supply unit.
Related link
Installing a power supply unit
52
Installing and removing system components
Summary of Contents for DSS8440
